DIY Tria Laser Hair Remover
Tria 4X Laser
The Tria 4X Laser System comes with a white carrying case, battery charger, skin sensor, instructions manual and FAQ guide. As with all laser devices, please read and understand directions before using. Tria uses a diode laser with five intensity settings and comes with free shipping, free returns, 30-day money back guarantee & 1 year warranty.
The Tria 4X Hair Remover is cordless and requires an initial charge before use. After charging, you must use the skin sensor to verify your skin color is not too dark. If the sensor blinks green, you are ready to begin. If it blinks red, your skin is too dark and you should not use the Tria.
**It should be noted that only the darkest skin will turn the sensor red. Tria recommends that you do a test run of one flash on an area you wish to treat. After 24 hours, if the test area shows no irritation, you are ready to begin.
How To Use Tria
To begin the hair removal process, first shave the area you wish to treat. You don't want to wax or use any method that pulls out the hair follicle because the follicle is what the laser will be working on. You place the Tria directly on your skin and and wait for beep.
Hold the unit in place until you hear a second beep meaning this section is complete and you move to the next area. If it emits a buzz rather than a beep, this means the treatment was not complete and needs to be repeated. You repeat these steps until the entire area has been covered. Treating both legs takes approximately 1.5 hours.
Some users may feel a slight tingling sensation during use. After treatment, a sensation like a light sunburn and dry, flaking skin may occur. After three treatments (2 weeks between treatments), users report a reduction in hair growth between 70% and 90%.